Repair manual

 

1. Use the cleaning cloth so that the broken/cracked area is free of dirt.
2. Take the sandpaper and roughen the affected area strongly.
3. Clean the affected area again with the cloth.
4. Cut the adhesive tape (2) to the desired length and round the corners with scissors.
5. Turn on the iron (4) to 2,5 of 3 points (approx. 150-180°), steam off (follow the instructions).
6. Place the tape (2) with the shiny side on the desired place (1) (fabric side out) and align it exactly
7. Always use the release paper (3) between the tape (2) and the iron (4).
8. Apply pressure with the iron (4) for about 5 seconds on the spots marked with the tape (2).
9. Apply the tape piece by piece around the bulges and curves.
10. Check again if the edges are cleanly applied and press again selectively on the whole tape.
11. Finally, seal the edges by applying a thin layer of superglue to the transition points from tape to shoe of the tape to the shoe. Drying time 5 minutes.
12. For heavily used areas (toe, inside, etc.) we recommend, after the glue has dried, to apply a second layer of tape to the damaged areas layer of tape onto the damaged area. Again, follow steps 4-11. (Note the manufacturer's processing instructions: https://dm.henkel-dam.com/is/content/henkel/tds-1867001-de-pattex-sekundenkle-ultra-gel-mini-trio-3x-1-gramm)